1. After the whole machine arrives, check whether the accessories and technical documents are complete according to the packing list, and check whether the whole machine and parts are damaged.
2. The user must lay a good foundation according to the basic drawing of the purchased product.
3. Install it according to the installation position of the basic drawing, so that each mechanism is in a horizontal state.
4. After the whole machine is in place, install the sensor and remove the fixing bolts of the weighing hopper to make the weighing hopper in normal working condition.
5. Check whether each transmission part is flexible and whether the bolts of each connection part are loose
6. Install the wiring of the electrical circuit according to the "Batching Controller Manual", including: main power cable and each motor cable, sensor cable and remote control cable.
7. Perform an empty car running test to check whether the direction of each motor is correct.
8. According to the requirements of the batching controller manual, perform a simulated batching cycle test, set small weighing for various materials, and check whether it can perform automatic cycle batching.
★ Special attention:
1. A knife switch should be set between the main power supply and the electrical box.
2. The neutral line of the batching controller power supply must not be connected to the ground line incorrectly, otherwise a serious accident will occur.
3. The batching controller must be reliably grounded with a resistance of no more than 4 ohms.
4. Sun-proof, rain-proof, dust-proof and shock-proof facilities should be set up at the location where the batching controller is placed.
