Normal concrete mixing station equipment mixes materials such as sand and gravel aggregate, cement powder, water, external additives, etc. according to a certain ratio, and finally transports all the mixed materials to the concrete mixer for mixing so that it becomes the concrete needed for our construction project.
In summary, the batching of concrete mixing station is very important, so i will tell you several aspects that need to be paid attention to when batching concrete mixing station:
Under normal circumstances, the batching of concrete mixing stations is a fully automatic control system. The proportion of various materials is set in advance on the computer, and the weighing and measurement are automatically carried out with small errors.
Since it is a machine operation, errors are inevitable, so the operator needs to observe and compare in time to see if the computer is normal.
When the concrete mixing station is in production, it is necessary to pay attention to whether there are errors in the measurement and whether there are residual materials, so as to ensure the accuracy of the measurement.
When admixtures are added to the concrete produced by the concrete mixing station, the mixing time should be appropriately extended.
Fly ash is a very common powder. If fly ash is added, the mixing time of the concrete mixer will be about 20 seconds longer than that of ordinary concrete. If there are other admixtures, the mixing time of the concrete will be extended by about 50 seconds.
The operators of the concrete mixing station must be familiar with the various control components of the concrete mixing station equipment and must be proficient in the correct operating sequence and regulations.
Only in this way can we handle the emergency correctly and avoid operating errors that cause equipment damage and material loss.
